Potassium hydroxide generally needs to be transported to the conveyor to transport the materials. In addition, the conveyor is also required for the transportation of products during packaging. However, sometimes some large blocks may be mixed in the transported materials, so what should be done to avoid the blockage of the conveyor.
Before we try to avoid the blockage of the conveyor, we first need to understand some conditions that may lead to the blockage. For example, if the operation is not carried out according to the correct method, it may lead to the blockage, In addition, if the conveying material is too large, resulting in the equipment load operation, then the equipment can no longer bear it, it may lead to blockage.
Therefore, in normal use, it is only necessary to control the transported potassium hydroxide. Generally, there will be no blockage. However, it is also necessary to avoid the situation that the equipment is idling and there is no material for transportation, because in this case, although there will be no blockage, it will directly cause serious damage to the equipment bearings.
In fact, it is very important to control the transportation of added materials when in use, but we all know that this measurement is very difficult to control if added manually, so in this case, we can choose to install a feeder to adjust the added measurement.
The above introduction is how to avoid the blockage of potassium hydroxide conveyor, because if a certain part is stuck, it will hinder the whole process.